NuMaker-M253LEB
| 1. | Install the preferred toolchain. Please make sure at least one of the toolchains has been installed. | ||||
| - | KEIL MDK Nuvoton edition – Full Cortex-M | ||||
| - | IAR EWARM | ||||
| - | NuEclipse GCC (for Windows) | ||||
| - | NuEclipse GCC (for Linux) | ||||
| 2. | Download and install the latest Nuvoton Nu-Link Driver. | ||||
| - | Download and install Nu-Link_Keil_Driver when using Keil MDK. | ||||
| - | Download and install Nu-Link_IAR_Driver when using IAR EWARM. | ||||
| - | Skip this step when using NuEclipse. | ||||
| 3. | Download and unzip the Board Support Package (BSP) | ||||
| 4. | Hardware Setup | ||||
| (1) Open the virtual COM (VCOM) function by changing Nu-Link2-Me VCOM Switch No. 1 and 2 to “ON”. | |||||
|
|
|||||
| (2) Connect the ICE USB connector to the PC USB port through a USB cable. | |||||
|
|
|||||
| (3) Find the “Nuvoton Virtual COM Port” on the Device Manger. | |||||
|
|
|||||
| 5. | Use the “Template” project as an example. The project can be found under the BSP folder. | ||||
| - | M253_Series_BSP_CMSIS_V3.XX.XXX | ||||
| - | SampleCode | ||||
| - | Template | ||||
| - GCC | |||||
| - IAR | |||||
| - Keil | |||||
| 6. | Open and execute the project under the toolchain. For detail setting, please refer to the NuMaker-M253LEB User Manual. | ||||
| 7. | User can see the result in the ternimal window on PC. | ||||
|
|
|||||
|
Resources |
|||||
|
User Manual | Microcontrollers | Software Development Tool | Driver (BSP) | Programmer | Nuvoton Official Forum | Nuvoton eStore
*Ordering Number : NK-M253LEB |
|||||
