FAQ
- M051 Base Series(95)
- M0518 Series(97)
- M0519 Series(43)
- M0564 Series(1)
- Mini51 Base Series(90)
- Nano100/102 Base Series(101)
- Nano103 Base Series(10)
- Nano110/112 LCD Series(100)
- Nano120 USB Series(111)
- Nano130 Advanced Series(110)
- NUC029 Series(94)
- NUC100/200 Advanced Series(102)
- NUC120/122/123/220 USB Series(116)
- NUC121/125 Series(1)
- NUC126 USB Series(2)
- NUC130/230 CAN Series(103)
- NUC131/NUC1311 CAN Series(98)
- NUC140/240 Connectivity Series(114)
- M451 Base Series(118)
- M451M Series(117)
- M452 USB Series(130)
- M4521 USB Series(1)
- M453 CAN Series(128)
- M463 CAN FD/USB HS Series(1)
- M467 Ethernet/Crypto Series(1)
- M471 Series(1)
- M479 Motor Control Series(1)
- M481 Base Series(4)
- M482 USB FS OTG Series(4)
- M483 CAN Series(4)
- M484 USB HS OTG Series(4)
- M485 Crypto Series(4)
- M487 Ethernet Series(4)
- M4TK Touch Key Series(25)
- NUC442/472 Series(130)
- NUC472 Series(1)
- NUC505 Series(138)
Products
Applications
Function
+
FAQ
What should user do if the WDT (Watchdog Timer) Reset of the NUC505 does not work properly? Issue Date:2018-11-28
When the WDT Reset occurs in the NUC505, the hardware mechanism of the WDT will pull the voltage of reset pin low to trigger reset; if the voltage of the Reset pin cannot be pulled low, the reset will not be triggered normally, and a hardfault may occur. Therefore, it is necessary to modify the circuit design. Refer to the design of the NUC505 development board for the circuit of the reset pin using the pull-up resistance value of 1kΩ, as shown in the following circuit diagram.
Products: | Microcontrollers ,Arm Cortex-M4 MCUs ,NUC505 Series |
---|---|
Applications: | |
Function: | Peripherals,Power Detection,Power-On Reset (POR),Low Voltage Reset (LVR),System Operation,Reset,Timer and PWM,Watchdog Timer (WDT) |