When the CPU is powered on, the high-speed internal oscillator (HIRC) is used as the clock source. After the Flash is stable, the Config value is read to switch to HXT. Therefore, during the period from power-on to Flash stabilization. The signal of the ICP Programming Tool can still be received for connection.

When the CPU clock source is set to HXT, and no clock source can be connected to the ICP Programming Tool, you can follow the steps below to connect to the ICP Programming Tool.

(1) Connect the chip to the PC through the ICE interface;

(2) Open the ICP Programming Tool on the PC; do not click Connection;

(3) Maintain the reset pin of the chip at low logic / Press and hold Reset Pin on the Tiny Board

(4) Click Connection on the ICP Programming Tool;

(5) Connect the reset pin of the chip to the high logic / Release the Reset Pin on the Tiny Board;

(6) Connect to the ICP Programming Tool.

Products:	Microcontrollers ,8bit 8051 MCUs ,Arm Cortex-M0 MCUs ,Arm Cortex-M23 MCUs ,Arm Cortex-M4 MCUs
Applications:
Function:	Peripherals,Clock Control,HXT,Memory,Config,Software and Tools,Nu Tools,In Circuit Programming (ICP) Tool

Video Center

Technical Support

Technical Community

Learning Center

Security

Partnership Innovation Center

FAQ

FAQ

What should user do when there is no HXT (high speed crystal oscillator) connected to the system and user switches the system clock source to HXT in Config, the CPU will have no clock source and cannot connect the system to ICP Programming Tool to re-program it? Issue Date：2018-11-27

以綠色半導體技術豐富人類生活的隱形冠軍

Content

Did you find the information you need ?

Layouts

Do you think it is easy to find the information you need ?

Layout style

Do you like the website color or picture configuration ?