FAQ
- M051 Base Series(95)
- M0518 Series(97)
- M0519 Series(43)
- M0564 Series(1)
- Mini51 Base Series(90)
- Nano100/102 Base Series(101)
- Nano103 Base Series(10)
- Nano110/112 LCD Series(100)
- Nano120 USB Series(111)
- Nano130 Advanced Series(110)
- NUC029 Series(94)
- NUC100/200 Advanced Series(102)
- NUC120/122/123/220 USB Series(116)
- NUC121/125 Series(1)
- NUC126 USB Series(2)
- NUC130/230 CAN Series(103)
- NUC131/NUC1311 CAN Series(98)
- NUC140/240 Connectivity Series(114)
- M451 Base Series(118)
- M451M Series(117)
- M452 USB Series(130)
- M4521 USB Series(1)
- M453 CAN Series(128)
- M463 CAN FD/USB HS Series(1)
- M467 Ethernet/Crypto Series(1)
- M471 Series(1)
- M479 Motor Control Series(1)
- M481 Base Series(4)
- M482 USB FS OTG Series(4)
- M483 CAN Series(4)
- M484 USB HS OTG Series(4)
- M485 Crypto Series(4)
- M487 Ethernet Series(4)
- M4TK Touch Key Series(25)
- NUC442/472 Series(130)
- NUC472 Series(1)
- NUC505 Series(138)
Products
Applications
Function
+
FAQ
What to do when the NUC505 USBD is set to Full-speed mode and the master sends the "SET REPORT" command but the NUC505 is not detected normally? Issue Date：2018-11-26
When the NUC505 USBD is in Full-speed mode, due to hardware limitations, the master will be unable to be detected normally after sending the "SET REPORT" command. This can be solved by setting the Set Endpoint buffer to increase the length by 4 Bytes.
/* Control endpoint */
USBD_SetEpBufAddr(CEP, CEP_BUF_BASE, CEP_BUF_LEN+4);
| Products: | Microcontrollers ,Arm Cortex-M0 MCUs ,NUC131/NUC1311 CAN Series |
|---|---|
| Applications: | |
| Function: | Peripherals,Connectivity,CAN |